Please refer to the table below for LED indicators for camera system statuses.
Color | Status | Meaning |
|---|---|---|
| Off | Error | No power. If your fan is not spinning and no LEDs are illuminated, then you need to check your power source and cabling. |
| Red | Error | System processor not booting. Micro SD card needs to be re-imaged. We refer to re-imaging the micro SD card as unbricking the camera. |
| Red Blinking | Error | If camera LED is also blinking red, then the camera update file loaded on the big SD card is corrupt. You can redo the software update. |
| Red / Green | Error | Test mode - you will not see this in normal operation. |
| Red / Yellow | Error | Configured for DHCP-only but no DHCP server has provided an IP address. Camera cannot communicate over Ethernet. DHCP-only is not supported yet, so you will not see this in normal operation. |
| Red/Magenta | Unused. | |
| Yellow Blinking | System boot in progress. Blinks for 26 seconds then turns solid yellow. May take up to 146 seconds the first time a recovery image micro SD Card is used. If the system LED continuously blinks yellow, additional troubleshooting instructions will get your camera running again. | |
| Yellow / Blue | Warning | System ready, Ethernet not connected. |
| Yellow | System ready, Ethernet connected, using fixed IP address 10.11.12.13 | |
| Magenta | System ready, Ethernet connected, using fixed IP address other than default (10.11.12.13) IP address. | |
| Blue Blinking | System boot in progress. Ethernet connected, camera using DHCP assigned IP address. | |
| Blue | System ready, Ethernet connected, using DHCP assigned IP address. | |
| White Pattern | System firmware update in progress. Do not power cycle. See table below. |